GlowROM Flash Programmer T48

I updated my IC programmer from the TL866II plus to the T48 and needed a new way to program the FlashROM’s that I have for the AMIGA . Some are of my own design , and others that I have bought in the past .

The adapter for the flash chips is the ADP-F48-EX-1, which has a chip on it that identifies the adapter . I did contact XGECU a while ago about getting some of these chips , but have had no reply whatsoever .

So I preceeded to reverse engineer the adapter , to create my own .

Parts that are needed are :-

2 x 20 pin header strip

2 x 21pin turned socket strip

5 pin 90 degree header strip

20cm 16 way idc ( ribbon ) cable

90 degree 16 pin IDC plug housing ( pcb mount )

1 x ADP-F48-EX-1 T48 adapter

1 x GlowROM Flash programmer T48 pcb

5 dupont socket to socket leads

You need to extend the 16 way IDC cable .

The 8 pin chip , resistor and capacitor need to be transfered from the ADP-F48-EX-1 T48 adapter to the GlowromFlash Programmer board . This will make the T48 think that the correct adapter is in the socket .

There are two pin one markings , one for the 40 pin Rom’s and one for the 42 pin Rom’s .

When programming you need to use the number of the flash chip on your flash rom DO NOT spoof it as a 27Cxxx chip .

And that is it programming A GlowROM Flash .